In the frame relay network the (CIR) represents the average bandwidth for a circuit that an ISP provider has under normal circumstances without any problem. In any condition or circumstances the bandw
Added: 03/16/2011,
Hits: 207,
Rating: 0,
Votes: 0 Add To Favorites
| Add Rating
When the data is being transferred from one destination to another there is always a possibility of the data loss or data might be corrupted when it reaches to the destination. In order to ensure that
Added: 03/16/2011,
Hits: 137,
Rating: 0,
Votes: 0 Add To Favorites
| Add Rating
Frame Relay technology was intended to be an intermediate solution for the demand for high bandwidth networking. It is a packet switching technology which relies on low error rate digital transmission links and high performance processors.
Added: 05/08/2000,
Hits: 471,
Rating: 0,
Votes: 0 Add To Favorites
| Add Rating
Frame Relay is the easiest data transfer protocol that as been ever designed by any one. Due to the designing of its protocols its data transfer speed is remarkable.
Added: 03/17/2011,
Hits: 136,
Rating: 0,
Votes: 0 Add To Favorites
| Add Rating
Frame Relay transfer system is high speed and high performance WAN protocol that is relatively cheap as compared to its other opponents. In the transfer of data there are two possible ways to transfer
Added: 03/17/2011,
Hits: 131,
Rating: 0,
Votes: 0 Add To Favorites
| Add Rating
If you are using a router, Frame Relay can be easily set up only on the interfaces that it supports without any hesitation; it is mostly supported on synchronous serial interfaces. Only a single comma
Added: 03/17/2011,
Hits: 120,
Rating: 0,
Votes: 0 Add To Favorites
| Add Rating
The Frame Relay has many different types of interface to monitor it and handle the situations. The management interface is the further extension of the protocols that are included in the Frame Relay.
Added: 03/17/2011,
Hits: 123,
Rating: 0,
Votes: 0 Add To Favorites
| Add Rating
Frame Relay provides a standard interface to the wide-area network for bridges, routers, front-end processors (FEPs), and other LAN devices. A Frame Relay interface is designed to act like a wide-area LAN- it relays data frames directly to their destinations at very high speeds. Frame Relay frames travel over predetermined virtual circuit paths, are self-routing, and arrive at their destination in the correct order.
Added: 02/01/2011,
Hits: 332,
Rating: 0,
Votes: 0 Add To Favorites
| Add Rating
